Skip to content

Not sure of your size? Read the stamp on your bar

[email protected]

KAKEI chainsaw chain logo

KAKEI part 1B4Q40X

10" 3/8" LP .043" 40DL Semi-Chisel Chain, 3-Pack

4.5 · 15,439 ratings

Ten-inch battery saws like the Ryobi P546 and Worx WG322 run a thin .043" chain with 40 drive links. We make that loop in semi-chisel form and box it in threes for yard owners who cut a little, often.

  • Bar length10"
  • Pitch3/8"LP
  • Drive links40
  • Gauge.043"

CHAIN SPECS

$24.95partner store price at our last check

  • German steel
  • Hardened rivets
  • Chrome cutters

Before you open the card

  1. 1Read the stamp

    Pitch and gauge are pressed into the bar near the mounting end.

  2. 2Count the links

    Count drive links on the old loop, or read them off its card.

  3. 3Match all three

    This loop is 3/8" LP · .043" · 40DL.

Where the stamp is

About this loop

A 10-inch cordless saw lives on the garage wall and comes out for fallen branches, fence-line brush and the odd bit of kindling. It rarely gets sharpened on time, so having two spare loops ready is the practical fix. Our R40-size chain uses the narrow .043" gauge these bars are cut for, plus low-profile teeth that ask little of a small motor. Owners of the LCS1020 and CMCCS610D1 use the same loop. We punch the plates from German steel, quench the rivets and oil every chain before it leaves us. Part 1B4Q40X.

Made for these saws

  • Ryobi P546
  • Worx WG322
  • LCS1020
  • CMCCS610D1

The saws named on our card for this loop. Your bar decides in the end: it must read 3/8" LP, .043" and take 40 links.